Keep unused ports on set clean from dust and your rig looking even more organized. Print in TPU to prevent the print breaking in the port! The print does also cover some other Lemo type connectors.

This adapter allows 4 antenna signals to be looped back from inside the rack to outside through extension cables. On the bottom there are various standard mounting wholes for a rack shelf. I got a spare one including cables on hand. Shoot me message if interested!

Strain release for original delivered StarTech cable.

Protect your unused D-Tap Ports. Can be printed in any strong layer adhesive filament but also plain PLA works pretty well.

The desk stand allows for an iPhone or a iPad to be mounted at a comfortable angle. It was especially designed to match the screen angle of an iPad to a MacBook for use with Apple Sidecar.

This cover protects your unused HDMI port from dirt and damage. Print it in TPU as you want the very best layer bonds so it does not crack while removing it and permanently block the port.

Protective cover for your unused full size SDI or BNC ports. The cover should be printed in TPU to function properly.

Antenna protective guard for small hd 703 bolt with 5g micro antennas.

This mount support attaches to the small rig full cage for the blackmagic pocket cinema camera to a metabones adapter for use with lens motors. Surprisingly it holds up incredibly well when printed even in PLA with sufficient wall counts and infill for more stability..

Permanent installed tray catcher for Tilta MB-TB12. The print is through heat melted on screws with nuts for a super secure filter fall protection.